Evolution RAGE3S3002 Manual de instrucciones descargar pdf (Pagina 30)

www.evolutionpowertools.com

NOTE: Approximately 75mm of the

Workpiece Support Bar should slide into the base to

provide positive location.

• Tighten the retaining screw.

• Repeat the above for the Left Hand side.

To remove a Workpiece Support Bar, simply loosen the

relevant retaining screw and slide the Workpiece Support

Bar from the machine. Store safely for future use.

THE REPEAT STOP (Fig. 42)

The use of the Repeat Stop can greatly aid the operator

when conducting repetitive cutting operations. When

many pieces of material all cut to the same length are

required, use of the Repeat Stop can assist accuracy

and efﬁciency.

Fitting the Repeat Stop

• Loosen the Repeat Stop thumb screws sufﬁciently

to allow the arms of the Workpiece Support Bar to

slide through the holes in the Repeat Stop.

• Position the Repeat Stop approximately half way

along the Workpiece Support Bar, and tighten the

thumb screws to minimize any movement.

• Attach the Workpiece Support Bar to the machine

base as previously detailed.

NOTE: By loosening the thumb screws the Repeat

Stop can be adjusted to the required distance from the

saw blade for repetitive cutting operations etc. The

Repeat Stop can be ﬁtted to either of the Workpiece

Support Bars but normally will be positioned to the

Right Hand side of the blade.

Fig.42

Repeat Stop in position

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 39 40

Sin comentarios

Evolution RAGE3S3002 Manual de instrucciones Pagina 30