Evolution RAGE3S3002 Manual de instrucciones descargar pdf (Pagina 23)

www.evolutionpowertools.com

THE MOTOR ON/OFF SWITCH (Fig. 19)

The ON/OFF Motor Trigger Switch is a non-latching

type. It is the upper of the two switches that are

positioned inside the Cutting HANDLE.

• Press the switch to start the motor.

• Release the switch to turn off the motor.

CHOP CUTTING

This type of cut is used mainly for cutting small or

narrow section material. The Cutting Head is gently

pushed down to cut through the workpiece.

The Sliding Carriage should be locked in its

rearmost position. (Fig. 20)

• Slide the Cutting Head to the rear as far as it will go.

• Tighten the slide lock screw. (Fig. 21)

• Place the workpiece on the table and against the

fence and secure with clamp(s) as appropriate.

• Grasp the saw handle.

• Turn the motor on and allow the saw blade to

reach full speed.

• Press the lower guard locking trigger to release

the Cutting Head.

The Lower Guard Locking Trigger (Fig. 22)

• Lower the Cutting Handle downwards and cut

through the workpiece.

• Allow the speed of the blade to do the work, there

is no need to apply undue pressure to the Cutting

Handle.

• When the cut has been completed, release the

ON/OFF trigger switch.

• Allow the blade to come to a complete stop.

• Allow the Cutting Head to rise to its upper

position, with the lower blade guard completely

covering the blade teeth, and the Cutting Head

locked in the upper position, before releasing the

Cutting Handle.

• Remove the workpiece

Fig. 19

Close up view of Cutting Handle switches

Fig. 20

Fig.21

Fig. 22

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 39 40

Sin comentarios

Evolution RAGE3S3002 Manual de instrucciones Pagina 23