Evolution RAGE3S3002 Manual de instrucciones descargar pdf (Pagina 21)

www.evolutionpowertools.com

• Return the Cutting Head to its upright position.

• Loosen the locknut on the 45

Bevel Adjustment

Screw.

• Use a Hex Key to adjust the Adjustment Screw in

or out as required. (Fig. 15)

• Tilt the Cutting Head to the 45

setting and

recheck for alignment with the Set Square.

• Repeat the above steps until the correct angular

alignment is achieved.

• Tighten the Adjustment Screw locknut securely

once alignment is achieved.

FENCE ALIGNMENT

The fence must be aligned at 90

(square) to a correctly

installed blade The rotary table must be set at ‘0

’ miter

angle.

The Fence is fastened to the table with two socket

head Hex screws positioned at either side of the fence

in elongated slots. (Fig. 16)

• Ensure that the Cutting Head is in the locked

down position with the latching pin fully engaged

in its socket

• Place a Set Square on the table with one short

edge against the Fence and the other short edge

against the Blade (avoiding the TCT tips). (Fig. 17)

• If adjustment is necessary, loosen the four Fence

adjustment screws using a Hex Key

• Re-position the Fence in its elongated slots until

alignment is achieved.

• Securely tighten the socket head Hex screws.

MITRE ANGLE POINTER ADJUSTMENT

NOTE: There are dual miter angle scales cast into the

front of the machines base. A small pointer attached to

the rotary table indicates the angle selected.

If necessary the pointer can be repositioned by

loosening its fastening screw using a #2 Phillips

screwdriver. Adjust as necessary, and then securely

tighten the ﬁxing screw. (Fig. 18)

Fig. 14

Close up view of pointer and screw

Fig 15

Close up view of 45

Adjustment screw

Fig. 16

Overhead view to show Hex Socket

Cap Screw

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 39 40

Comentarios a estos manuales

Sin comentarios

Evolution RAGE3S3002 Manual de instrucciones Pagina 21

Comentarios a estos manuales