Evolution RAGE3S3002 Manual de instrucciones descargar pdf (Pagina 18)

www.evolutionpowertools.com

DEPTH STOP (Fig. 8)

Use of the depth stop allows the operator to cut slots

in the workpiece.

The downward travel of the Cutting Head can be set so

that the saw blade does not completely cut through the

workpiece.

NOTE: When using the Depth Stop it is advisable that

the depth of cut is checked using a scrap piece of

timber to ensure that the slot cut is correct.

By making a cut in the workpiece, and then repeating

the cut but with the workpiece slightly repositioned to

the left or right, it is possible to perform trenching cuts.

To use the depth stop:

• Loosen the locking wing nut. (A)

• Adjust the thumb knob (B) to limit the saw heads

travel to the required depth.

• Once set to the desired depth, tighten the wing

nut (a) against the retaining bracket to lock the

depth stop and ensure that there is no movement.

• When cutting is complete re-adjust the depth

stop so that the Cutting Head can be locked in the

down position by the head latching pin.

THE SLIDING UPPER FENCE SECTION

The Left Hand side of the Fence has an adjustable

upper section. Adjustment may be necessary to

provide clearance for the moving Cutting Head when

acute bevel or compound angles are selected.

To adjust the Fence:

• Loosen the thumbscrew. (Fig. 9)

• Slide the upper section of the Fence leftwards to

the required position and tighten the thumbscrew.

• Conduct a ‘dry run’ with the power off to conﬁrm

that there is no interference between moving

parts as the Cutting Head is lowered.

Fig. 8

Close up view of the Depth Stop

Fig. 9

View of adjustable Fence from the rear

highlighting the locking thumbscrew

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 39 40

Sin comentarios

Evolution RAGE3S3002 Manual de instrucciones Pagina 18