Evolution RAGE3S3002 Manual de instrucciones descargar pdf (Pagina 29)

www.evolutionpowertools.com

USE OF OPTIONAL EVOLUTION ACCESSORIES

Not supplied as original equipment. All accesories

can be purchased from Evolution Power Tools. See

‘Additional Accessories’ section.

DUST BAG

A Dust Bag can be ﬁtted to the extraction port at the

rear of the machine. The Dust Bag is for use when

cutting wooden materials only.

• Slide the Dust Bag over the dust extraction port,

ensuring that the spring clip grips the port holding

the Dust Bag securely in place. (Fig. 40)

NOTE: For operational efﬁciency empty the Dust Bag

when it becomes 2/3 full. Dispose of the contents of

the Dust Bag in an environmentally responsible way. It

may be necessary to wear a dust mask when emptying

the Dust Bag.

NOTE: A workshop vacuum extraction machine can

be attached to the dust extraction port if required.

Follow the manufacturers instructions if such a

machine is ﬁtted.

WARNING: Do not use the Dust Bag when cutting

metallic materials.

EXTRACTION PORT BLANKING PLUG

Use the blanking plug in place of the dust bag when

cutting steel based materials.

EXTRACTION PORT ADAPTOR TUBE

Use the Adaptor Tube to connect the extraction port

of the machine to suitable commercial workshop

vacum extraction equipment (not supplied) which have

Ø30mm internal bore hoses or inlet ports.

WORKPIECE SUPPORT BARS (Fig. 41)

Workpiece Support Bars can be ﬁtted to either or both

sides of the machines base as required.

• Right Hand side. Loosen the support retaining screw

located in the top front of the machines base.

• Insert the workpiece supports bars into the

retaining holes in the base. Push fully home to

ensure positive location.

Fig. 41

Support Bars being ﬁtted

Fig. 40

Dust Bag being ﬁtted

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 39 40

Sin comentarios

Evolution RAGE3S3002 Manual de instrucciones Pagina 29