Evolution Fury 6 Manual de instrucciones descargar pdf (Pagina 18)

www.evolutionbuild.com

18

approximately 3mm.

Adjust the cutting height of the blade by

adjusting the height of the machine table

as previously described. This machine is

not suitable for cutting rebates or stopped

grooves.

A vacuum cleaner or workshop dust

extraction device can be connected to

the extraction port found at the rear of the

machine if required.

1. On/Off Switch Operation

To start the machine:

a) Slide the trigger switch safety locking

slide downwards.

b) Press the trigger switch. The machine will

start.

c) Push in the trigger locking button (Fig. 23)

for continuous motor operation.

When cutting is completed, gently press the

trigger switch to release the trigger locking

button. The machine will stop and the safety

locking slide will automatically deploy.

2. Rip cutting

Rip cutting is cutting along the length of a

piece of material rather than across it.

Rip cutting should always be done with the

Rip Fence set to the desired width and on the

RH side of the machines table.

Note: Check that the rip fence is locked

in position and is parallel to the saw blade.

Check that the riving knife is properly aligned

with the saw blade.

When ripping small section material a push

stick should be used to feed/guide the ﬁnal

300mm of the material past the blade. A

push stick should always be used when

making cuts of less than 300mm.

When ripping long boards or large panels

always use a remote work support or enlist

competent trained help.

Feed the workpiece through the saw keeping

it indexed against the rip fence. Use smooth,

steady pressure and employ a push stick if

necessary. Hands should never be in line

with the blade.

MAINTENANCE

WARNING: Ensure that the machine is

disconnected from the mains supply before

any maintenance tasks or adjustments are

attempted.

Cleaning

After each use the machine should be

cleaned. Remove all sawdust etc from the

visible parts of the machine with a vacuum

cleaner. A vacuum cleaner can also be

connected to the machine dust extraction

port at the rear of the machine. This should

remove debris from the inside of the

machine. Never use solvents to clean plastic

parts, as solvents can damage them. Clean

only with a soft damp cloth.

Riving Knife

The riving knife is a very important

component and comes factory ﬁtted and

correctly aligned and adjusted. The riving

knife prevents the work from binding as it

passes through the blade. Inspect the riving

knife at regular intervals and replace it if it is

worn or damaged.

Note: Use only a genuine Evolution Riving

Knife, as this is a dedicated component for

this machine. Non genuine parts could be

dangerous. If in any doubt, please contact

the Helpline.

Push Stick

A plastic push stick is provided with the

machine. When not in use store the push

stick on the machine.

Note: If the push stick becomes damaged

it should be replaced. If the operator makes

their own push stick, we recommend that it

follows the same pattern as that supplied.

Replacement push sticks are available from

Evolution Power Tools.

PRECISION SETTING OF ANGLES

WARNING: Before making any adjustments,

or carrying out maintenance to the saw,

make sure that it is disconnected from the

mains supply.

1 2 ... 13 14 15 16 17 18 19 20

Comentarios a estos manuales

Sin comentarios