Evolution 80GX Especificaciones descargar pdf (Pagina 24)

24 Hangar 9 Sukhoi SU-26MM SE

 4. Repeat Steps 1 though 3 to install the remaining wing

panel.

 5. Attach the canopy hatch to the fuselage using the

four 4-40 x 1/2-inch button head screws and four #4

nylon washers that were removed at the beginning

of the radio installation. Tighten the screws using a

5/64-inch hex wrench.

Decal Placement

Required Parts

Decal sheet Completed airframe

Required Tools and Adhesives

Paper towel Spray bottle with water

Plastic squeegee Dish washing liquid

Hobby scissor

Hobby knife with #11 blade

When applying the decals for your model, use a spray

bottle and a drop of dish washing liquid sprayed in the

location of the decal to allow repositioning of the decal.

Use a paper towel as a squeegee to remove excess water

from under the decal. Allow the model to rest overnight so

the remaining water can evaporate.

Center of Gravity

An important part of preparing the aircraft for flight is

properly balancing the model.

CAUTION: Do not inadvertently skip this step!

The recommended Center of Gravity (CG) location for your

model is 7

-inch to 8-inch (194mm–203mm) located at the

wing root near the fuselage. Measure back from the leading

edge as shown and mark the location of the CG on the

bottom of the wing with a felt-tipped pen.

With a helper, lift the aircraft with your index finger at the

location marked on the wing. Make sure the aircraft is

upright when checking the CG. If the nose of your aircraft

hangs low, add weight to the rear of the aircraft. If the tail

hangs low, add weight to the nose of the aircraft. Stick-on

weights are available at your local hobby store and work well

for this purpose.

After the first flights, the CG position can be adjusted for

your personal preference.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 30 31 32

Sin comentarios

Evolution 80GX Especificaciones Pagina 24