Evolution 80GX Especificaciones descargar pdf (Pagina 17)

17Hangar 9 Sukhoi SU-26MM SE

 3. Attach the header to the engine using the hardware

provided with the header or engine.

Note: Before installing the tuned pipe, you will want

to install the landing gear as described in the section

“Installing the Landing Gear” on Page 22.

 4. Place the pipe in the fuselage, passing it through the

full tuned pipe mount. Connect the tuned pipe to the

header using a tuned pipe coupler.

Note: Most tuned pipes can be installed from the hatch

opening into the fuse by carefully positioning the inlet side

of the pipe beside the tank during installation. There will be

some tuned pipes that may need to be installed through the

front opening in the fuselage prior to fitting the engine to

the firewall.

 5. Pass the clear tubing through the holes in the mount

in the fuselage and through the holes in the half

tuned pipe mount. The half mount will be secured in

the fuselage using two 4-40 x 1/2-inch socket head

screws and two washers. Use a 3/32-inch hex wrench

to tighten the screws. This mount will secure the pipe

in the fuselage.

 6. Check the fit of the cowling over the tuned pipe. It

may be necessary to trim the cowling slightly to

provide clearance for the tuned pipe.

Note: A small of canopy glue on the threads of the cowl

mounting screws will allow for easy removal, but help

prevent the screws from vibrating loose in flight.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 31 32

Sin comentarios

Evolution 80GX Especificaciones Pagina 17