Evolution EVO42 Manual de instrucciones descargar pdf (Pagina 15)

EVO42

www.evolutionsteel.com

• OperatetheRed switch (Fig. 4) situated at the rear of the

machine to energise the magnet.

• CheckthatthemachineisrmlyattachedtotheMildSteelplate.

• OperatetheBlack motor switch located on

the top of the machine. (Fig. 5)

• Allowthemotortorunforafewsecondstocheckforany

unusual noise or vibration.

• Donotusethemachineifanyvibrationorunusualnoisesare

detected or if magnetic adhesion is questionable. Have the

machine serviced by a qualiﬁed person, or if under guarantee

refer to the guarantee agreement.

• Turn‘OFF’themachinewhenalltestinghasbeencompleted.

INSTALLING A CUTTER

Selectacuttersuitablefortheoperationtobeperformed.Check

the cutter to ensure that it is sharp and is not damaged in any way.

• Insertthepilotpinintothecutterensuringthat

it slides smoothly. (Fig.6)

• Raisethecuttingheadtoitshighestposition.

• Checkthatthecuttersecuringgrubscrewslocatedinthe

spindle are not protruding into the spindle bore. (Fig.7)

• Alignthetwoatsonthecuttershaftwith

the grub screws in the spindle.

• Starttotightenoneofthegrubscrewsandatthesametimeslightly

rotate the cutter backwards and forwards until the grub screw is fully

tightened. This will ensure that the grub screw is located squarely

onto the ﬂat preventing the cutter from becoming loose.

• Tightentheremaininggrubscrew.

Fig. 4

Fig. 5

Fig. 6 Fig. 6

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 23 24

Sin comentarios

Evolution EVO42 Manual de instrucciones Pagina 15