Evolution BATTERY JIGSAW Instrucciones de operaciones descargar pdf (Pagina 8)

8

2. INSTALLING OR REMOVING A BLADE

Note: The Battery Pack must be

disconnected from the machine when

installing or removing the blade.

Installation:

• Remove the Battery Pack.

• Check that the jigsaw blade is of the

correct type.

• Pull back on the collet chuck sleeve using

your nger and thumb of one hand.

• Insert the blade into the chuck fully

ensuring that the blade teeth face

forwards.

• Release the chuck sleeve.

• Check to ensure the blade is securely

gripped by the chuck.

• Check to ensure that the back of the blade

has engaged into the groove

in the guide roller.

• Replace the battery pack.

Removal:

Note: A recently used blade can be very

hot. Allow such a blade to cool down before

attempting to remove it from the machine.

• Stop the machine with the chuck at the

bottom of its stroke.

• Remove the Battery Pack.

• Set the Cutting Action Selection Switch to

position 3.

• Pull back on the collet chuck sleeve using

your nger and thumb of one hand.

• Using your other hand gently ease the

blade rearward to release any pressure

being exerted by the guide roller on the

back of the blade.

• Pull the blade downwards and away from

the machine.

3. ON/OFF TRIGGER SWITCH

This tool is tted with a variable speed

Trigger Switch that delivers higher speed as

the trigger pressure is increased.

The Trigger Switch is also tted with a brake

function which stops the chuck immediately

when you quickly release the trigger.

4. TRIGGER SWITCH SAFETY LOCK

The Trigger Switch can only be operated

once the Safety Lock has been disengaged.

1. To disengage the safety lock press the

Safety Lock slide button on either the Right

Hand or Left Hand side of the handle.

2. Press the trigger switch to start the

machine.

Note: The Safety Lock will automatically reset

to the ‘Safe’ position when the trigger switch is

released and the machine has stopped.

5. LASER CUTTING GUIDE

This jigsaw is tted with a Laser Guide which

can be particularly useful when cutting

straight lines. Only switch the Laser Guide on

when you are about to make a straight cut, and

switch it off when the cut has been completed.

The switch is located on the front of the

machine. Press the button once to switch the

Laser Guide ‘On’. Press once more to switch

the Laser Guide ‘Off’.

WARNING: Do not look directly into the

laser beam, or point it at anyone. Do not use

the Laser Guide if the material to be cut is

reective.

1 2 3 4 5 6 7 8 9 10 11 12

Comentarios a estos manuales

Sin comentarios